3M primer PT896 may promote adhesion strength & bonding force build-up.For most substrates,primer PT896 may increase higher adhesion & perform different bonding forces due to different substrates,surface preparation,surface contaminations,pressure sensitive adhesive type & formulation,pressure sensitive adhesive constructions and so on.
3M底漆PT896可以促进附着力强度和提升粘接力。对于大多数基本,底漆PT896可能使附着力提高,并且可用于不同的底材,比如表面处理、表面污染、压敏胶粘剂类型、压敏胶粘剂结构等等。
Surface Preparation:表面处理
1.The bonding surface must be relatively clean and dry.
必须保持基本表面清洁和干燥。
2.Contaminated surfaces should be cleaned with 50/50 Isopropyl Alcohol and water mixture.A clean lint-free cloth should be used.
有污染的表面需要用1:1的异丙醇和水混合物清洁,然后用干净的无尘布操干。
Application/使用说明:
Shake primer TP896 well before using.Apply a thin uniform coating to the bonding surface using the minimum amount that will fully coat the surface.Allow primer PT896 to dry thoroughly before applying tape.This is usually accomplished in 5 minutes at room temperature.Be sure the primed surface remains free from contaminants prior to applying the tape.Porous surfaces may require 2 application of primer PT896 for uniform coverage and good adhesion.Allow first application of primer to dry before applying the second coat.Primer PT896 may be applied with brush or swab.It can also be applied with a pressurized folw gun,knurled roller or other similar type of application equipment.
3M底漆TP896之前使用请先摇一摇。在被粘基材上均匀的涂上薄薄的一层PT896涂剂剂。等底涂剂安全干燥后再贴上胶带。在室温下通常5分钟就好。确保涂好底漆的表面在粘接之前干净、无污染物。为了达到最佳效果,多孔表面需要两面都均匀的涂上底漆PT896。请于底漆干完干燥后再进行第二道工序。底漆PT896可以应用刷子刷或棉签涂抹。它也可以应用加压水流枪喷涂,滚花辊或其他类似设备类型。
Copyright © www.king-olipel.com 版权所有 | 粤ICP备:13018270号